Every gas dryer is equipped with an ignitor that produces a flame from the gas supply. A broken ignitor prevents the dryer from producing any heat, thus making drying your clothes impossible. Replacing a broken ignitor is not really as hard as it may seem, but it does require some reading and planning. This article will give the readers some basic steps to execute replacement of a broken dryer ignitor ge dryer repair pasadena.
Before proceeding with the repair and replacement steps, make sure that you get the correct ignitor for your dryer. To do this, check and take note of your dryer model number. You will need this information (unit model number) in your purchase at an appliance repair store. The model number will assist the technician in the store to find the proper parts for your specific dryer unit. It is important to remember that the elements on the ignitor are very sensitive, proper handling is a must. Some of the steps below may get too technical, so if you are feeling a bit uncomfortable, you can always call your trusted repair man to do the job.
Disconnect the dryer’s power cord from its electrical outlet. Close the gas supply valve on the gas line leading to the diver.
Lift the lint screen out off its compartment. Remove the two screws next to the lint screen compartment.
Insert a putty knife into the gap between the top panel and the front of the dryer. Press the putty knife into the top panel clips 2 inches from each front corner.
Disconnect the wiring harness that connects to the flame sensor on the burner can. The wirings can be easily removed using your hands.
Using a wrench, remove the screws that hold the burner assembly bracket to the base of the dryer. Pull the burner assembly out.
The burner assembly is connected to the igniter by a wire, disconnect this wire. Remove the remaining screws that hold the igniter to the assembly. Then pull off the defective ignitor and replace with a new one. Reverse steps 5 to 2.
Finally, turn the dryer on to check if it is running properly. Make final setting configurations and tightening of the connections. After if everything is running smoothly, reposition the dryer back its place and then plug the dryer back to the wall outlet.